Walk Along — Jiggy On The Northern Tier

by | Dec 21, 2020 | 4 comments

** NOTE ** This article is part of the Walk Along series. These are first person accounts showing the thoughts, strategies and actions surrounding particular situations on the river, putting the reader in the mind of the angler.

It’s dark in the garage, and I haven’t done this for a while. In the thin light of the 4Runner’s hatch, I double check that everything’s in place before closing the lid and sliding into the cold driver’s seat. With a 4:45 am departure, my boots should be wet just as dawn breaks — and I’ll meet the trout at first light.

In my rearview mirror, I watch the garage door slide closed before I put my foot on the accelerator. It’s been a while since I’ve set out this early for a solo trip, and I have high hopes for a piece of water that I haven’t fished in two years. With a full tank of gas and a hot cup of coffee, they’ll be no stops until I hit the river — just a long drive north, dodging deer until daylight.

When dawn breaks, my tires crunch and grind over dirt and gravel in a small pull-off used by hunters a few times a year but not by fishermen.

I pause after my first boot lace is tied. And while looking up through a cloud of warm breath, I blow into my wool gloves a bit, slowing down to listen. My favorite run is two-hundred yards through the hemlocks, and I hear the murmur of moving water, teasing and calling me through thinning twilight.

Even after my walk, it feels cold on the river. But I expected that. I’ll start with the streamer that I ended with yesterday evening, still strung up, because it’s just bad luck not to.

Let’s do it . . .

Walk Along

On the second cast up and across a trout flashes from behind a boulder. Not a bad start. But give him another look, with a head flip. Now stall it this time right at the merger seam off the corner of the rock. And wait, wait, let it fall . . .

The sighter is all I can see when the streamer is deep, but I know where it is — four feet to the fly, because the sighter has contact. Good. Maintain tension and watch for the slow down on the colored line. There it is. The fly’s in the strike zone. Now speed lead it the rest of the way down the seam. Nice.

That looked good. No hits, but I’m glad I found the strike zone here, because I’ve set a baseline. Without seeing the bottom, I’m able to ride above the riverbed on the next half-dozen drifts. Deliver up and across, find the cushion when the sighter slows, and then speed lead it through. These are good drifts.

I’m spreading it around now. And my feet keep moving. Without taking my eyes from the water, I feel the riverbed with my feet. I’m mobile — constantly wading upstream through knee-deep water while giving a few casts to each lane and dark pocket close to good structure. Keep moving.

Photo by Bill Dell

My feet are finding potholes — depressions up to twelve inches deeper than the surrounding riverbed. I don’t remember many potholes in this stretch, but I haven’t fished it more than a handful of times either. These potholes are their own type of structure. And I’ve landed some of the best fish of my life from good potholes that are nearly hidden — revealed to the perceptive angler only by a minor slick on the surface.

READ: Troutbitten| Where to find big trout — Part Three: The Special Buckets

Cast. Speed lead. Repeat. Keep moving. In fifteen minutes, I’ve waded twenty yards upstream at least. It’s a good pace for streamers. And now, another pothole. It’s time for a fly change.

A quick wrist flip-and-strip delivers the streamer to my line hand. Clip. Zip. Place the Half Pint into the working streamer box and pull out a Craft Fur Jiggy. Davy Knot. Pull. Clip. Cast. I make the change in seconds.

With the right weight, any streamer can be encouraged to dive through the water column and jig. And using the Mono Rig today allows for precision of fly placement. The Half Pint streamer that I started with dropped into place often enough for the speed lead, but nothing rides the bottom like a lead ball jig, and the first drift on the Craft Fur Jiggy makes me smile. For the first time since tucking my kids into bed last night, I speak aloud. “Well, that’ll ride through the potholes . . .”

It does. And instead of relying on the sighter to signal the strike zone so much, I start using the jig to feel the bottom. That’s its strength. The super power of a lead ball jig is feeling the bottom and riding over it. I feel the ticks on rocks. A tungsten beaded jig of equal weight would hang too often with this tactic. Only lead does this just right.

Tick and glide. Tick and glide. Another cast. The next seam. More wading. And now pause. This spot is too good not to move a trout, and it’s my first piece of prime water. I’ve had my heart set on it since I entered the water a half hour ago.

And for the first time since the walk in, I lift my head to look around. The sun is up now. It’s still behind the ridge and masked by clouds, but Sunday has made its appearance. And I’m thankful I’ve made the trip. The morning is mine, and I have until noon to forget about everything else.

And I do. It’s just me and the mountain, with the river as our companion.

READ: Troutbitten |Streamer Presentations — The Crossover Technique

The Craft Fur Jiggy coasts into the juiciest part of the glide, under the dancing bubbles of a foot-wide seam. I see the darker water of a channel below and let the Jiggy find it. There it is! I’m on edge for this drift, ready to set. Now tick and glide through. Strike!

Nothing. But I’m glad I set the hook. One of the other ticks that I felt on the way through may have been a strike. And that’s the trouble with relying on feel. It forces me to guess a lot. But that’s my strategy right now, and I’m sticking with it. Heighten the focus.

Cast again. Feel the current push on the line as the Jiggy sinks. With my index finger on the rod blank I sense the slightest nuances in this long leader as it rolls over my trigger finger and into my line hand to pick up slack.

I missed the channel that time. The sighter never slowed, and the Jiggy ticked just once. Cast again, and think about a dead drift at first. Tuck. Lift just the slack coming back. The rod elevates. The fly finds the zone and then ticks. Good. Now lead through.

Tick and glide. Tick and glide. There’s a hit! A quick fight, a long distance release . . . and he’s off. That’s alright.

That trout took on what was mostly a dead drift, broken up by the stops and pauses of touching rocks. So I cast again and repeat the look.

Another hit! Both of those were subtle. But the fish are in this prime channel. Two trout were willing to hit, and that’s good feedback, so I adjust.

Tuck it in again. Now find the bottom within a second or two. There it is. Ride through the channel and sink into the potholes. Touch less by adding a jigging motion. Too much that time, and the drift is over.

Refine this. Make it better. Repeat. Smaller jigs. Five inches, at most, and then let it fall until the touch. Do it again. There’s room for about four jigs and drops before the drift finishes out below me. Cast, drift. Tick and glide. Fish on!

Sixteen inches of wild brown trout. A fine fish that hit on the drop. Not what I’m looking for, but he’s big enough to give me some data. He took the fly on the jig-and-drop. So I’ll repeat it.

About five more casts through the main chute under the bubbles, and then I’m mobile again. I move on because I can’t be stubborn with a streamer at the end of the line. The next prime water is a softer chute, but if I’m careful, I can repeat the same successful look on the Jiggy.

Tuck cast. Drop. Tick. Jig. Drop. My line hand retrieves the slack. And now, in this slower water, I’ll use the line hand for the jig, because the rod tip motion is too much. But first . . . locate the bottom.

Next cast. Tick. Now lead downstream. Slower. No, even slower. Match the water speed. There it is. That’s the strike zone. Now cast again to the same spot, tick this time and add the jig with the line hand. Tuck. Drop. Tick. Lead. Now just a five-inch strip with the rod tip up. Maybe less. Pause the lead ever so slightly for the fly to drop. Then repeat.

Focus. Another jig-and-drop before the drift ends and . . . HEY NOW!

Fish on. Fast fight, and a quick pic.

That’s the one I came for.

Fish hard, friends.

 

Enjoy the day.
Domenick Swentosky
T R O U T B I T T E N
domenick@troutbitten.com

 

Share This Article . . .

Since 2014 and 900+ articles deep
Troutbitten is a free resource for all anglers.
Your support is greatly appreciated.

– Explore These Post Tags –

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

More from this Category

When Gear Gets In the Way

When Gear Gets In the Way

No matter what we’re into, there’s a time when the learning of skills reaches a critical mass, when it’s time to do rather than read more about it and buy more gear.
. . .There’s a time for learning. There’s time for preparation. And then there’s time for doing — for putting all of it into practice, making the casts, covering water and catching fish . . .

Five Keys to Reading the Sighter (with VIDEO)

Five Keys to Reading the Sighter (with VIDEO)

Control. Options. Precision. These are the most attractive aspects of fishing a tight line system, and the sighter is the key to it all.

A sighter is more than a strike indicator. It also shows depth, angle, speed and contact. It points to our flies and takes away the guesswork. For an angler who learns to read all of this on the sighter, that colored line above the water provides a most significant advantage to the underwater game . . .

Getting Closer

Getting Closer

When I start wondering why the fishing seems slow, I first check my distance. Have I started creeping the cast too far beyond that perfect baseline? If so, I reel in a couple turns. I wade closer, staying behind the trout and being cautious with my approach.

Hook Sets Are Not Free

Hook Sets Are Not Free

Mike had landed on a common phrase that usually triggers a response from me. It’s one of the myths of fly fishing, and it carries too much consequence to let it go. Hook sets are not free. There’s a price to pay. Oftentimes that cost is built into our success. And other times, the costs of too frequently setting the hook pile up, stealing away our limited opportunities . . .

(VIDEO) Finding Your Best Fishing Angles

(VIDEO) Finding Your Best Fishing Angles

Choosing your casting position based on visibility, working with the light rather than fighting against it, is not an intuitive decision. But by simply moving our body, by wading up, down or over, we change the light, the highlights and the glare on the water. In this way we can see through a section of river from the left side that was under impossible glare from the right . . .

What do you think?

Be part of the Troutbitten community of ideas.
Be helpful. And be nice.

4 Comments

  1. OK Dom Great story … You did it .. I’m gone fishing today !!The hell w/ shopping Thanks Brian

    Reply
    • Brian, me too going fishing today. Hope get a hit from a big fish that got away last week; or any of his/her big companions.
      Tightlines, happy fishing!

      Dom, thanks as always for the day in the life of a skilled fisher!

      Reply
  2. Those are some great browns you caught Dom. Time to get Jiggy with it. Lol!

    Reply

Submit a Comment

Your email address will not be published. Required fields are marked *

Recent Articles

Recent Posts

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

Pin It on Pinterest