Streamer Presentations — The Head Flip

by | Dec 4, 2018 | 13 comments

I learned to trout fish by drifting live minnows on a spinning rod. My uncle taught me. We used a two inch long needle to thread a small loop of six pound mono into the mouth and out the vent of a fathead minnow. The needle was removed before a double hook went through the loop and into the minnow. The wounded creature lived for some time, depending on how skilled we were with the needle, and how good we were at dead drifting.

We cast up and across. And if I gave the fathead some slack, it always struggled toward the bottom. I watched the minnow’s performance in shallow water enough to understand some things. It tried always to face upstream. And when the split shot on the line above was carried downstream, the minnow was forced to follow as it was dragged downstream headfirst, until more slack was given in the system. Whereupon, inevitably, the fathead would attempt to right itself by turning to face the current again.

And each one of those turns — every time the minnow changed direction — was a trigger for hungry trout.

READ: Troutbitten | What happened to Laurel Run? The story of a stocked trout stream and a fisherman

Years later, when I picked up the fly rod, I fished streamers relentlessly. And I caught trout. But it was decades before I fully realized the possibilities, before I understood that I had complete control over the streamer’s angle, and that I could induce an eye-catching head flip at nearly any point throughout the drift.

The Head Flip

A good river fisherman forms a mental image of his bait, lure or fly under the water. And a good streamer angler understands how the weight in the fly (or on the line) reacts to the surrounding currents and the tension on the tippet. These are all processed factors leading to a good guess of what an unseen streamer is doing underneath.

And the key part of that mental image is the head orientation. The head can be upstream, downstream, across stream, or at some point in between. And when the angler changes the tension and direction of the attached line, the streamer angle changes.

That’s what I call the head flip.

Photo by Josh Stewart

Why it works

The head flip can happen anywhere in the water column, though it’s especially deadly with the streamer close to the bottom, right in front of a waiting trout.

A head flip makes the progress of the fly stall for a moment.

Imagine a streamer traveling downstream and across the current, maybe on a slow slide off the bank. Now picture an angler changing the line angle and forcing a head flip. In the transition from down and across to up and across, the fly stalls for a moment. And the changing profile angle catches a trout’s attention.

Imagine next a fly downstream and across from the angler, let’s say only twenty feet out. The streamer’s head faces the fisherman, into the current, until . . . our fisherman changes the rod and line position enough to flip the head of the streamer downstream and across. Again there’s a slight stall, a minor pause in progress during the shift. And the head flip here looks a lot like a faltering baitfish, like a struggling animal trying to right itself against the currents.

READ: Troutbitten | Streamers as an easy Meal — The Old-School Streamer Thing

The head flip, at any angle, draws attention because it looks available to the trout. It looks vulnerable, if just for a moment. Perhaps it’s wounded or has let its guard down. And in that instant, our trout sees an opportunity.

WHAM!

From this . . .

. . . to this.  (A well-chewed Dungeon)

Dell

Just a few years ago, I fished a braided section of a favorite local river with my friend, Bill Dell. I took the left side, and Bill worked up through a series of channels on the right. An hour later, we met at the top, and I expected that Bill had experienced the same slow fishing I had.

“I caught one. How’d you do over there?” I asked my friend.

“Pretty good. I caught a bunch of fish on streamers,” Bill said with a shrug of the shoulders. “Some of them were big too.”

When I replied with some skepticism, Bill pulled out his phone and showed me pictures — a series of large wild brown trout all pushing twenty inches.

“What the hell were you doing!? I was fishing streamers too,” I said, pointing to the fly on my hook keeper.

I glanced over to Bill’s rod and saw a drenched olive Headbanger that closely matched my own.

“SAME FLY!” I said, pointing at his streamer.

I followed along with Bill for the only hour I had left that day, and we talked about his presentation. I watched him pick up three more trout and gain the interest of a handful of others. Bill was the first person I saw using a head flip so deliberately. And as I watched him, I remembered seeing those strung minnows faltering and fighting to stay balanced.

At close range, Bill flipped the streamer’s head by lifting the rod tip and dramatically changing the angle — so the streamer head followed. At long range, Bill mended the line to force the head flip. And that day, his head flip drew one strike after another. It’s like the trout were just waiting for it.

Variations and Specifics

Since that day with Bill, I’ve been much more deliberate about manipulating the head angle of my streamers. I put to use what I learned about fishing with dying fathead minnows, and I’ve learned to manipulate the line with my rod tip to force the head flip in key spots — in the prime spots.

The head flip works with weighted flies or with light flies and split shot. It works with sinking lines for the weight too, but the flip does not happen as dramatically or as precisely.

With a Mono Rig, I have maximum control over the angle of the streamer’s head, simply because I’m in excellent contact with the fly. I fish streamers on the Mono Rig a lot, even at long range, and performing the head flip is a big reason why.

READ: Troutbitten | Fly Fishing Streamers on the Mono Rig 

By mending fly line, a skilled angler can achieve a very similar head flip, and he can do it at some angles that are tough with a Mono Rig. Both methods have their moments.

And no matter the rig or the weight used to get the fly down, when a streamer changes positions in the water, it draws attention. In fact, the head flip is the most reliable trigger in my arsenal of streamer tricks.

The Double Flip

One more tactic here — try the double flip. On a tight line with a Mono Rig, have the streamer working with its head pointed down and across. Now swing the rod tip upstream. The fly pulses and swoons for a moment. And just as it completes that shift in orientation, swing the rod tip back downstream to the original position to complete a double flip.

Try this with a visible fly, and you’ll see the streamer struggle. You’ll watch it look alive and available as it pauses. The marabou, the hackle, the rubber legs and more that we tie into our streamers pulses and expands for a moment — an articulated fly hinges just right. The double flip looks like a wounded fish struggling to gain its balance before it falters — an easy meal.

Do It

With some on-stream experimentation, you’ll find endless ways to make the head flip happen.

The change in angle and the pause in progress of a good head flip looks like what a trout is waiting for. For just an instant — when the fly stalls and falters — our hungry fish sees an opportunity. And if he’s hungry enough . . . he pounces. You gotta love it.

Fish hard, friends.

 

Enjoy the day.
Domenick Swentosky
T R O U T B I T T E N
domenick@troutbitten.com

 

Share This Article . . .

Since 2014 and 600 articles deep
Troutbitten is a free resource for all anglers
Your support is greatly appreciated

– Explore These Post Tags –

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

More from this Category

Why do we miss trout on a nymph?

Why do we miss trout on a nymph?

Late hook sets are a problem, as is guessing about whether we should set the hook in the first place. But I believe, more times than not, when we miss a trout, the fish actually misses the fly. However, that doesn’t let us off the hook either. It’s probably still our fault. And here’s why . . .

Loss of contact, refusals and bad drifts. All of these things and more add into missing trout on nymphs. So how do we improve the hookup ratio?

Fishing Light

Fishing Light

You’ve probably been wading upstream on a favorite trout stream and seen another angler’s lost tackle. Maybe the whole mess was in the streamside trees, with split shot and bobber attached, or a misguided F13 Rapala with rusted hooks. Maybe you’ve snagged a pile of monofilament stuck in waterlogged branches and lodged against a rock. And when you’ve seen all that mess, maybe you were stunned by how heavy the tackle was. Are you with me? . . .

Be a Mobile Angler

Be a Mobile Angler

Wading is not just what happens between locations. And it’s not only about moving across the stream from one pocket to the next. Instead, wading happens continuously.

Many anglers wade to a spot in the river and set up, calf, knee or waist deep, seemingly relieved to have arrived safely. Then they proceed to fish far too much water without moving their feet again. When the fish don’t respond, these anglers finally pick up their feet. Maybe they grab a wading staff and begrudgingly take the steps necessary to reach new water and repeat the process.

This method of start and stop, of arriving and relocating, is a poor choice. Instead, the strategy of constant motion is what wins out . . .

Beyond Euro Nymphing

Beyond Euro Nymphing

Euro nymphing is an elegant, tight line solution. But don’t limit yourself. Why not use the tight line tools (leaders and tactics) for more than just euro nymphing?

Use it for fishing a tight-line style of indicators. Use it for dry dropper or even straight dries. And use it for streamers, both big and small.

Refining these tactics is the natural progression of anglers who fish hard, are thoughtful about the tactics and don’t like limitations. I know many good fly fishers who have all come out the other side with the same set of tools. Because fishing a contact system like the Mono Rig eventually teaches you all that is possible . . .

New Structure | Old Structure

New Structure | Old Structure

One of my favorite places in the world is a deeply shaded valley that runs north and south between two towering mountains of mixed hardwoods. The forest floor has enough conifers mixed in to block much of the sunlight, even in the winter. The ferns of spring grow tall, and thick moss is spread throughout. The ground remains soft enough here that all large trees eventually surrender to the valley. When they can no longer support their weight in the soft spongy ground, they fall over, leaving a broken forest of deep greens and the dark-chocolate browns of wet, dead bark. It’s gorgeous.

Fallen timber also dictates the course of this cold water stream. The fresh tree falls force the creek to bend away from the hillside. Rolling water carves away the earth and lays bare the rocks — these stones of time, as Maclean puts it. And when water cuts into a neighboring channel, previously dry for centuries, new river banks are undercut and fresh roots exposed . . .

Light Dry Dropper in the Flow

Light Dry Dropper in the Flow

. . .The flow of the fly line through the air is finesse and freedom. Contrasted with nymphing, streamer fishing, or any other method that adds weight to the system, casting the weightless dry fly with a fly line is poetry.

The cast is unaffected because the small soft hackle on a twelve-inch tether simply isn’t heavy enough to steal any provided slack from the dry. It’s an elegant addition that keeps the art of dry fly fishing intact . . .

What do you think?

Be part of the Troutbitten community of ideas.
Be helpful. And be nice.

13 Comments

  1. Well, thanks. I’ve been fly fishing 35 years and seldom these days do I come across anything very useful in the “how to” department. I’ve been unintentionally flipping heads, now I’ll do it with gusto.

    Reply
    • That’s nice, man. Thanks.

      Reply
  2. Nice thoughts to keep in mind. I’m going to get out the first chance I get. I thought I read here one time that fishing a nymph off the bend of a streamer fly can be a good setup. Did I read that here?

    Reply
    • I think you probably read that here. After 350+ articles, I can’t remember where right now. Ha! I do run nymphs with streamers a fair amount. Just depends on how I’m fishing the streamer. I’ll mention that downside, though: You will foul hook some trout. The best way to avoid is to keep the trailer at least 18″ from the streamer. But no matter how long your trailer is, you will still accidentally hook some fish that come and swipe at the streamer and get hooked by the trailer.

      Reply
  3. Thanks for another great set of tips Domenick! I look forward to trying the head flip.
    I am curious to know your thoughts on using a Duncan Loop or a No Slip Loop knot with streamers. Do you think it allows for greater streamer movement than a more conventional knot; clinch, davy, etc.? Any concerns with a loop knot being more visible to the the trout?

    Reply
    • I have been using the no slip loop knot for 10 years on trout and steelhead. I lose a few especially in colder water with the knot slipping out. I do think I get more strikes with a loop knot, but when I went after Salmon in MI in September, the loop knot lost me a number of fish. I went back to improved clinch knot and no slips for the rest of the trip. Just my observations. I might have to try the duncan loop too.

      Reply
  4. I think I get it, but video of that would be cool, I guess. 🙂

    Here’s a thought that I’ll leave with you, Domenick. As you know, I am in marketing and I’ve heard our contacts from billion dollar companies ask us for videos to help them better use the equipment they buy from us. You can understand my hesitancy about handing over a crap video to AT&T, for example, but they always say, “It doesn’t have to be fancy. Just use your phone. That’s all we need.” I know what they mean now!

    Reply
    • Hi Tomas,

      Well, I refuse to put crappy videos out there, honestly. Lot’s of views or not, I won’t do a video unless it’s done right.

      I do agree that a video would be good here. But that’s the case for over half the stuff I write, I think. My plan with Troutbitten is to focus on one thing at a time. Frequent videos are coming. So are podcasts, a Troutbitten Shop and a book or two. All in due time. Troutbitten continues to grow because guys like yourself are supportive, so thank you.

      But rest assured, the heart of Troutbitten will always be the words here on these pages.

      Cheers.

      Dom

      Reply
      • I kinda figured you’d say that, but I am not one to tell myself “no.” Heh heh. Cheers.

        Reply
  5. Domenick,
    You drove the nail right through the wood on that story. You article explained to me why a few of my biggest fish took the fly when they did. A couple months ago my best friend taught me to agitate a nymph on a long drift for Salmon. This is the next step for me, I hope I will be teaching him this one.

    Thank you and Happy Holidays,

    Reply
    • Cheers, man.

      Reply
  6. If you want a video the bass guys use a very similar triggering retrieve using jerk baits or twitch baits.

    Reply
    • Right on. I’ve learned a lot from a very good bass fisherman friend of mine. He’s my favorite friend to fish streamers with.

      Reply

Submit a Comment

Your email address will not be published.

Recent Articles

Recent Posts

Pin It on Pinterest