Streamer Presentations — The Touch and Go

by | Feb 28, 2021 | 6 comments

Trout lay with their bellies on the bottom of the river more than anywhere else. It’s a resting zone with slower currents and a place to hide or blend in. The riverbed is also the breakfast, lunch and dinner table for our favorite fish. It’s where the bugs are. It’s where the baitfish live too. And we’ve all seen that getting our streamer deeper usually elicits more strikes than riding near the surface.

Want to get deep? Want to be sure the fly is low enough? Then touch the bottom and hold it there for a moment before lifting, drifting or stripping again. Try the Touch and Go.

Be ready, and hold on tight.

Minnows

The minnow game of my youth was fun. And among the many strategies we practiced, sometimes we let the split shot fall all the way, to rest on the bottom of the river. The live, strung minnow, just six to twelve inches beyond the shot, was taken down by the weight. And as the creature reached the sand or rocks, it looked for a safe place to hide and rest.

Just as the minnow started to settle, or when it struggled to gain its equilibrium in the bottom flow, we’d pick up the shot and bounce it downstream before allowing it to fall and settle again. In the right time and place, the technique was a winner. Trout would rip into the baitfish just as it settled — or sometimes just as I moved the minnow again.

Eventually, what I did with that minnow became the Touch and Go with a long fly.

Bunny Bullet paired with split shot for the touch and go. The tactic is described below.

Naming Rights

When my boys were very young, maybe about four and six years of age, I’d take them to the nearby airport, just for something unique to see and do. And one time, we watched a single engine Cessna approach the runway before it touched down and lifted off again. The unexpected sight surprised both boys. My oldest son turned to me with wide eyes and said, “Dad, maybe he forgot something, and he’s going back for it.” I chuckled about that for a long time.

In aviation, the touch-and-go is a common way for pilots-in-training to practice landings. The plane touches down on the runway and then takes off again without coming to a full stop. Pilots often circle around to practice this again and again.

With Joey and Aiden that day, I understood just enough about airports and planes to know that this was called a touch and go landing. I was also fishing streamers a lot, every time I hit the river. And I’d been working on transferring that specific minnow tactic from my youth, of resting the minnow and then moving it. The two concepts blended with the boys and the airport that day, and the Touch and Go has been an effective streamer presentation for me ever since.

READ: Troutbitten | The Meat Eater Minority — Streamer Fishing Myth vs Truth

Water For It

The Touch and Go isn’t for every water type, nor is it for every river. If your favorite creek has a bunch of submerged wood wedged against an uneven, rocky bottom, then this will never be your favorite tactic.

Early on, I read articles and books about crawling the streamer along the bedrock. It sounded like a great idea. But in the waters I was fishing at the time, it was simply impossible to touch like that without hanging up on every other cast.

Some rivers have rocks covered with weeds. Some are coated with algae. Many places are loaded with logs and fallen branches along the riverbed. And none of these are a good match for the Touch and Go.

Sandy, gravely sections of river are best. Look for anywhere that the fly might stand a good chance of touching down and resting without getting stuck or picking up vegetables all the time. Some of my favorite rivers are a perfect match, and some are the worst. It doesn’t take much testing to find out where this presentations is best.

I’m gonna miss winter. I always do . . .

Flies For It

Any streamer can work with the Touch and Go, so I often mix it in with my rotation of presentations, no matter what fly is tied to the end of the line. But when I want to focus on the Touch and Go, there are a few things I consider.

When fishing slower tactics that give trout long moments to see the fly, I choose small to medium sized patterns. For me, that’s between one-and-a-half to three-and-a-half inches. I save the larger flies for faster tactics. A bigger fly is just more for a trout to reject, especially if they see it for a while.

Because the fly actually rests on the bottom for a moment, I choose flies that have built-in motion without being stripped. Marabou and rabbit fur are hard for a trout to ignore while the fibers wave and flutter in even the slowest currents. Most streamers incorporate materials that move, but for example, I wouldn’t choose something like a Clouser Minnow for the Touch and Go. (Maybe I should.)

I rarely choose articulated patterns for this technique. Because they are mostly larger than the sizes mentioned above, and that second hook doubles the chances that the fly will hang up.

Jigs and other flies than invert seem to be the perfect match here. And, no doubt, they are some of my favorite choices. I like a Craft Fur Jiggy and a Bunny Flash for the Touch and Go, and I mix in the tactic with what I consider the crossover style of streamer fishing. With a jig, I like to do what we call the Sawyer pivot. The head touches, and with the right current, the fly rotates (pivots) on the ball jig head, as the materials catch the current. The Craft Fur Jiggy is perfect for this.

Bunny Flash and the Craft Fur Jiggy. Good partners to have on the water.

But we don’t need jig flies for the Touch and Go. I routinely make it work with nearly every streamer in my box. One of my favorites is the beadless version of the Bunny Bullet Sculpin.

Real sculpins, of course, are bottom dwellers. They are relatively poor swimmers, and they seem to be a big trout’s favorite meal. I fish the Bunny Bullet with heavy split shot placed six inches up. Imagine an upstream presentation, where the Bunny Bullet now drifts and bounces back downstream. As I’m in touch with the split shot, the fly has six inches of freedom to move and rotate around the shot — free to move where the currents might take the fly. And when I allow the split shot to rest on the bottom, the streamer may swing around, from a head downstream orientation to a head upstream position, doing its own kind of Sawyer pivot. It’s a damn good look.

READ: Troutbitten | Streamers As An Easy Meal — The Old School Streamer Thing

The Trigger

The Touch and Go is another tactic that can be performed with many different streamer rigs, but it’s perhaps best done with a Mono Rig or tight line system. A fly line with a short leader pulls on the streamer almost constantly, but if you are close enough to overcome that influence, the tactic is viable.

However you rig up, the key is to use enough weight, either in the fly or on the line. (For me, that’s at least a gram, even in low water.) This allows the streamer not just to reach the bottom but also to rest there.

READ: Troutbitten | Series | Know Your Weights and Measures

How long should it rest? I don’t wait long. Maybe it’s my impatience, but the Touch and Go is more of a pause for me than a rest. Most times, the fly stops for a couple seconds or less.

What happens next? Do something that lifts the fly from the bottom a few inches. With my rig, it’s usually a rod-tip lift. And I follow that with a short strip or glide. Sometimes, I use the Touch and Go a few times throughout a long drift. But more often my drift length is shorter, and I have room for just one or two cycles.

A hapless, resting fly in the proximity of a big wild trout gets attention. It’s vulnerable. I’ve seen trout pick the fly off the bottom as it rests, but that is rare. Usually, the trigger to eat is when the fly lifts from its rest. That’s often the moment when a good trout just can’t take it anymore . . .

Josh, finding his own path.

Imagine

Visualizing your streamer is a next-level skill that produces results. In fact, when I fish any fly under the water and out of sight, I immediately begin to imagine what that fly looks like down there, where it is and where it’s going next.

Sometimes, I don’t drift or strip the streamer all the way through. Instead, I plot a course for the fly, looking through the water while reading the river’s structure. And I look for an appropriate landing zone for the Touch and Go.

Fish hard, friends.

READ MORE : Troutbitten | Category | Streamers

** Donate ** If you enjoy this article, please consider a donation. Your support is what keeps this Troutbitten project funded. Scroll below to find the Donate Button. And thank you.

 

Enjoy the day.
Domenick Swentosky
T R O U T B I T T E N
domenick@troutbitten.com

 

Share This Article . . .

Since 2014 and 700+ articles deep
Troutbitten is a free resource for all anglers.
Your support is greatly appreciated.

– Explore These Post Tags –

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

More from this Category

Cherry Picking or Full Coverage?

Cherry Picking or Full Coverage?

  Today, Hatch Magazine published an article that I wrote about two different approaches on the river. Here are a few excerpts ... -- -- -- -- -- -- -- -- ... Like a slow and silent time-lapse parade, over the span of an hour, the next fisherman took the position...

Take Five

Take Five

2:15 pm. Conditions are perfect and the trout should be active, but I’ve caught so few fish that I still know the slim count. Six. That’s four wild browns and two stocked rainbows that found their way here from only God knows where. But stocked bows have no regard for...

Fly Fishing Strategies: Tags and Trailers

Fly Fishing Strategies: Tags and Trailers

Sometimes trout are feeding so aggressively that the particular intricacies of how nymphs are attached to the line seem like a trivial waste of time. Those are rare, memorable days with wet hands that never dry out between fish releases. More often than not, though, trout make us work to catch them. And those same particulars about where and how the flies are attached can make all the difference in delivering a convincing presentation to a lazy trout.

Two nymphs can double your chances of fooling a trout. But there are downsides. Here are some strategies for rigging and getting the most from two fly rigs.

Streamside | Hatch Mag Tight Line Leader

Streamside | Hatch Mag Tight Line Leader

We've gotten a lot of questions, comments and reactions to a few recent articles that we published about Sighters, Tight Line Rigs and Why Fly Line Sucks. It's cool to see so much interest. Many of the questions are about the mono rig itself, and there is definitely...

The Mono Rig and Why Fly Line Sucks

The Mono Rig and Why Fly Line Sucks

For presenting nymphs and streamers to river trout, fly line sucks. There, I said it. Now I have to defend it. Most underwater deliveries require weight, and using a very long, monofilament leader to cast that weight is more efficient than using fly line; it keeps you...

What to Trust

What to Trust

The tall man crossed the old railroad bridge above me. He paused at the midpoint, lingered and watched me cast for a moment, then he bellowed downstream to me with a voice full of triumph. “I caught a bunch! They’re taking Zebra Midges just under the surface.” “Not...

What do you think?

Be part of the Troutbitten community of ideas.
Be helpful. And be nice.

6 Comments

  1. I’ve used jigs for crappie, bass, and bluegill, but have never tried them on trout. After reading this article and the linked one, I’m gonna have to get some material and tie a few to try next time I’m out.

    Thanks for broadening my horizons.

    Reply
  2. I once talked to a fly fisherman on the San Juan River who was using a similar technique to what you seem to be describing . He was using flies that were tied on a jig hook made of mostly marabou. He had some great days and some not so great days. But he traveled all the way to the River and that is the only technique he used.

    Reply
  3. What’s the gray & brown jig with the blue collar? Interested in sharing the recipe? Looks nasty! Thanks Dom!

    Reply
    • Hi Jason. Good eye! That’s what we call a Blue Collar Worker. That one is a variation. I like it tie with a silver bead and white barred legs, I think. Whole thing is in the prototype kind of stage. Good fly.

      Dom

      Reply
      • It looks great. Looks like a dressed-up jiggly slumpbuster. Looking forward to seeing more when you get it dialed in.

        Reply

Submit a Comment

Your email address will not be published. Required fields are marked *

Recent Articles

Recent Posts

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

Pin It on Pinterest