Night Fishing for Trout — Bank Water

by | Aug 12, 2018 | 2 comments

** This Troutbitten article is part of the Night Fishing for Trout series. You can find the full list of articles here. **

On the luckiest nights, large and medium sized trout move to the shallows, searching for an easy meal. Trout visit thin water when they feel protected by the cover of darkness, and because they find baitfish of all types unguarded and ready to be devoured. This is also when trout are most vulnerable to the skilled night fisher.

I have a bank-first approach on most nights, hoping I may hit it right and find actively feeding fish near the edges. On some rivers I wade to the middle and fish back to the boundary. And where the water is too deep to wade the center, I may stay tight to the bank, working downstream by swinging my flies or working upstream against the bank and drifting them. Regardless of the presentation used, bank water is my first target.

It’s not all the same, of course. There are deep undercuts around the outside bends, and shallow gravel bars on the insides. And while all of it’s worth a shot, I have my favorite — give me the shallow stuff.

First Crack

The rooted undercut banks with deep holding water are hard to pass up. And I’ll cast to them, but not first. I like shallow bank water best — from eight inches to two feet of depth and close to the bank. Trout here seem most willing to feed at night, and if I catch one I expect to hook a few more in the same type of water. Trout like to do what their friends are doing.

Perhaps the banks are most productive because they provide the best target. Even on darker nights, an angler gains a good sense about where the edge of the river is located. There may be similar water nearby (and it may hold baitfish), but it can be harder to find and fish effectively than the edge of a river.

“Trout here seem most willing to feed at night, and if I catch one I expect to hook a few more in the same type of water. Trout like to do what their friends are doing.”

So I spend a good half of my nights fishing the perimeters. And good bank water is found with varying speeds. I have confidence in sections that flow at a healthy jogging pace, and I like lazy backwater that’s barely moving. Everything in between those two speeds is a good target. Seasonally, if the river is warming and approaching the high sixties (Fahrenheit), I find fewer fish in the backwater and more in the riffles. However, that preference might flip in the colder months.

Look around. Prime bank water at night may very well be the kind of place you’d walk through during the day. It’s right where you might stand to cast into the deeper stuff. At night, try reversing your impulse — stand in the deep water and fish to the shallows. And if that doesn’t work, then by all means, cast to the other bank too.

Search for areas like deep buckets and troughs, places where you might nymph up the largest trout during a day trip. Then find the water next to it that tapers out to a level just ankle deep. Start there. On many nights, the trout start there too.

Fish hard, friends.

 

Enjoy the day.
Domenick Swentosky
T R O U T B I T T E N
domenick@troutbitten.com

 

Share This Article . . .

Since 2014 and 900+ articles deep
Troutbitten is a free resource for all anglers.
Your support is greatly appreciated.

– Explore These Post Tags –

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

More from this Category

Podcast: Finding Contact — Tight Line Skills Series, #5

Podcast: Finding Contact — Tight Line Skills Series, #5

Contact is visual. It’s about reading the sighter to know that we are in touch with the flies from rod tip to the nymph or split shot. It’s not about touching or ticking the riverbed. Instead, the contact we’re looking for is seen on the sighter.

With contact, we know everything about the depth and speed of our flies. We know where they are, and we determine where they are going. That’s the advantage of a tight line (contact) nymphing system . . .

Podcast: Recovering Slack — Tight Line Skills Series, #4

Podcast: Recovering Slack — Tight Line Skills Series, #4

To dead drift a nymph, we cast it upstream. And as the river flows downstream, it sends the fly back toward us, creating slack. Usually, we simply pick up that slack and maintain contact with the fly (sometimes directly, sometimes slightly).

Slack maintenance is a critical skill. And if the goal is to be in contact with the nymphs and know where they are — if this is a tight line rig — then allowing too much slack in the system destroys everything that we’re working toward. We recover the slack in three ways: by lifting the rod tip, by leading the rod tip, and with the line hand.

Podcast: Stick the Landing — Tight Line Skills Series, #3

Podcast: Stick the Landing — Tight Line Skills Series, #3

Part three of this Troutbitten Skills Series focuses on sticking the landing. Because after putting ourselves in great position to present the fly, we shouldn’t waste the perfect tuck cast and delivery. As the fly hits the water, all the elements of our system are in position and ready to drift. That’s sticking the landing.

Like a gymnast who tumbles, somersaults and then lands on two feet with no body movement, the best completion of a cast happens with no extra movement. Instead of landing and then recovering or correcting, we stick the landing, ready to drift.

Strategies for Pressured Trout — Something Different or Something Natural?

Strategies for Pressured Trout — Something Different or Something Natural?

Trout learn to see some colors, some materials, some shapes and movements as fake. And when they see the same fake fly often enough, they stop eating it. That’s what we mean by angler pressure. So, part of the game becomes a guess about what flies the trout have learned to reject and how we can turn the fish on again.

That’s the unnatural thing about trout seeing too many fishermen and too many flies . . .

Podcast: Turnover and Tuck Casting — Tight Line Skills Series, #2

Podcast: Turnover and Tuck Casting — Tight Line Skills Series, #2

Part two of this Troutbitten Skills Series focuses on the tuck cast. A good tuck is a turnover cast — where the loop unfolds completely in the air. In fact, a tuck cast is a fly-first entry, and it’s perfect for setting up the tight line advantage, where we keep everything up and out of the water that we possibly can.

We tuck cast not just to get deeper, but to setup the fly, tippet, sighter and leader in the best possible position to drift the flies down one seam. Accuracy starts with a good tuck, and not just accuracy over where the fly goes, but where all the parts of the leader go too . . .

What do you think?

Be part of the Troutbitten community of ideas.
Be helpful. And be nice.

2 Comments

  1. I’m just starting in on your night fishing articles. Are you turning your flashlight on and shining it on the water or does that spook fish?

    Reply

Submit a Comment

Your email address will not be published.

Recent Articles

Recent Posts

Domenick Swentosky

Central Pennsylvania

Hi. I’m a father of two young boys, a husband, author, fly fishing guide and a musician. I fish for wild brown trout in the cool limestone waters of Central Pennsylvania year round. This is my home, and I love it. Friends. Family. And the river.

Pin It on Pinterest